Steps of DIY Garage Door Installation

Steps of DIY Garage Door Installation

DIY garage door installation is not something impossible to be done by you. Well, you have to be independent person and doing many things by yourself. Some people probably need the expert to install they garage door; however, since we can find any do-it-yourself project of installing the garage door, probably you can do that by yourself. That is not a magic when you do your DIY garage door installation, but that is something that very great. Well, here is the step for you when you want to do the garage door installation with your do-it-yourself project.


Actually, garage door is a heavy thing and probably some people cannot do that by them self. However, DIY garage door installation can keep some money of yours because you do not need to hire the employers from the manufactures. The thing that you have to pay attention of is the manual from the manufacture. Well, the first step that you need in your DIY garage door installation is you need to release the tension. That is important to release the tension of the torsion spring to begin you garage door installation. After that, you have to disconnect the existing your garage door opener. In doing this step, you have to start with the panels of the door from the top. Then, remove the hinge that connected with the panel.


 The third step in the DIY garage door installation process is installing the door panels. Well, in beginning your new garage door installation, you have to prepare the door panels first. After that, you have to attach the hinge on the top of every panel that already installed by you. Then, we go to the next step. The next step of installing the garage door in our DIY garage door installation is that your hinges needed to be secured. After that, you have to install your track. In installing your track, you can start with attaching the brackets in the vertical tracks. Well, you have to check it once again in your manual, to make sure that you are not in wrong step.



The next step of your DIY garage door installation is that you need to attach or add the spring assembly to the track and after that you need to bolt the tracks together and make sure that you use the right size for your bolt. This is not enough for your DIY garage door installation, you still need to install the spring and you have to put it in the center of your door opening. You also need in install the pulleys and the torsion inside of the header bracket. And almost the last step is that you need to put the cable on it.


For finishing your DIY garage door installation, do not forget to once again checking the spring and tightening it. In the whole of your process, you have to make sure that you always read the manual that you get, for avoiding the wrong things that probably you did. That is all about DIY garage door installation.